Model 620s

Options

Accessories

Motor options: 220/240 VAC 1-phase; 460 and 575 VAC 3-phase
Flat profile type F-265 for doors up to 20' wide also available in: 20, 18-gauge galvanized steel; 22, 20-gauge stainless steel; 16-gauge (.050") aluminum
Bottom bar also available in: galvanized steel, stainless steel and aluminum
Guide options include galvanized steel, powder coated steel
Hood available in powder coat, stainless steel and aluminum; sloped hood also available
Brackets also available in powder coat, galvanized steel
IP65 (NEMA 4/4X equivalent) control panel
Sensing edge for improved safety
Additional set of photoelectric sensors
Optional push buttons, loop detectors, radio control, motion detectors or any combination thereof available for door operation/control
PowderGuard® Premium powder coat and PowderGuard® Max hardened powder coat available in approximately 200 colors as well as colormatching to specification
PowderGuard® Textured Finish: Industrial textured powder coat provides a thicker, more scratch resistant coat for added product protection on guides, bottom bar and head plate
Uniformly spaced glazed acrylic vision lites available in 3” x 5/8” or 10” x 1”

‍

Colours

Actual door color may vary from the digital representation shown here.

Color samples are available by request.

Powder Coat Color Options

PowderGuard® Premium powder coat options are available in approximately 200 colors as well as custom matching to specification. PowderGuard®Textured Finish: Industrial textured powder coat available in 11 colors provides a thicker, more scratch resistant coat for added product protection on guides, bottom bar and head plate.

Features

STANDARD MAX WIDTH:

up to 20' (6096 mm) depending on gauge and slat type

STANDARD MAX HEIGHT:

up to 20' (6096 mm) depending on gauge and slat type

MOUNTING:

Interior or exterior face of wall

CURTAIN FINISH:

Gray, Tan, White or Brown polyester top coat

WIND LOAD:

20 psf

BOTTOM BAR:

Two PowderGuard® Premium powder coated black angles (min. thickness 3/16”) with weatherstrip

HOOD:

24-gauge galvanized steel primed; motor and end cover provided

BRACKETS:

Min. ¼” hot rolled primed, PowderGuard® Premium powder coated black steel

GUIDES:

Three structural steel angles PowderGuard® Premium powder coated black; With high cycle UHMW wear strip

STORMTITE™ PERIMETER SEAL SYSTEM:

Exterior guide seal, interior hood baffle, bottom astragal

ACTUATOR:

Single open/close/stop push button station incorporated into control panel

DOOR ROLL:

Direct driven, springless roll with integrated shafts; self-aligning grease-able sealed bearings; door does not require counterbalance device

CONTROL PANEL:

Electronic controller with microprocessor self-diagnostics. Digital readout indicates door action, alarm conditions, and fault conditions. Time delay self-close timer and non-resettable cycle counter is included. One open/close/stop push button station integrated in control panel. Enclosure is IP54 rated (NEMA 3 equivalent).

CURTAIN:

Interlocking roll-formed slats, end locks attached to prevent lateral movement; ; Flat profile type F-265 for doors up to 18’'4" wide – 22-gauge galvanized steel; For doors between 18’4” and 20’0” – 20-gauge galvanized steel

SAFETY DEVICES:

Built-in brake mechanism provides additional peace-of-mind against uncontrolled curtain travel.
Photoelectric safety sensors with guards - provide obstruction monitoring during door operation to help prevent injury and damage

OPERATION:

Direct drive integrated gear/motor/brake assembly; Drive assembly and limit sensors are factory pre-assembled; Hand chain for power outage. Horsepower appropriate to door size/weight; 230 VAC 3-phase motor